Filter
Top Products
3-8 Installing Hardware Options
Writer: Michele Wray Project: Compaq ProLiant 1850R Setup and Installation Guide Comments: 333172-002
File Name: D-CH03.DOC Last Saved On: 1/29/99 8:15 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4. Press the module into the socket while pushing the latches inward until
the latches snap into place
.
5.
Replace the server cover.
6.
Push the server into the rack, secure with thumbscrews and reconnect
cables.
7.
Power on server and use the System Configuration Utility to reconfigure
your system.
Adding Memory to the ProLiant
1850R Server
You can expand server memory by installing Compaq DIMMs (Dual Inline
Memory Modules). The system supports up to four Registered SDRAM DIMMs
installed in slots on the System Board. Memory can be added one module at a
time.
You must observe the following guidelines when installing additional memory:
DIMMs installed in the ProLiant 1850R server must be 100-MHz
registered SDRAM, 3.3-volts, 72-bits wide, and ECC.
All DIMMs installed must be of the same speed, for example, all
100-MHz.
The server is shipped with at least one DIMM in DIMM socket 1
(system board connector J12).
DIMMs should be installed in sequential order starting with DIMM
socket 1.
Table 3-2
DIMM Option Kit Part Numbers
Part Numbers DIMM Option Kit Description
313613-B21 32-MB Option Kit
313614-B21 64-MB Option Kit
313618-B21 128-MB Option Kit
313616-B21 256-MB Option kit