Filter
Top Products
D-2 Installing a New Battery
Writer: Michele Wray Project: Compaq ProLiant 1850R Setup and Installation Guide Comments: 333172-002
File Name: K-appd.doc Last Saved On: 12/14/98 10:50 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Installing the System Board Battery
WARNING: The System Board contains a clock/CMOS lithium
battery. The lithium battery may explode if mistreated. The battery
is soldered in place and may not be removed. Do not abuse or
disassemble. Use only replacement batteries supplied by Compaq
Computer Corporation (spare part number
160274-001).
To install the new battery, complete the following steps:
1.
If the server is on, place it in Standby and disconnect the power cord-(s).
See to Chapter 2, “Server Installation Overview”.
2.
Pull the server forward in the rack for access to the inside of the server.
3.
Remove the server cover.
4.
Locate the battery header. The following illustration identifies the header
location for the new battery.
Figure D-1. Battery jumpers on the system board
5. Change the jumper on header E2 from pins 6-7 to pins 5-6.
IMPORTANT: When a jumper is on header E2 / pins 6-7, the internal
battery is used. When a jumper is on header E2 / pins 5-6, the external
battery is used.