Filter
Top Products
Monitor: JFFS2 File Systems
Katana®752i User’s Manual 10006024-04
15-12
JFFS2 FILE SYSTEMS
This section describes the commands for the read-only JFFS2 file systems. These com-
mands assume a valid JFFS2 file system in Flash with support provided for two partitions:
• Base of partition 0 is 0xE8180000
• Base of partition 1 is 0xE8000000 + (Total_Flash_Size/2) + 0x180000
ls
The ls command lists the files in the directory.
Definition:
ls [directory]
fsinfo
The fsinfo command prints information about file systems.
Definition:
fsinfo
fsload
The fsload command loads the binary file from the Flash bank with offset of ‘off’.
Definition:
fsload [off] [filename]
chpart
The chpart command changes the partitions (partitions 0 and 1 supported).
Definition:
chpart [part]
MEMORY COMMANDS
The memory commands allow you to manipulate specific regions of memory. For some
memory commands, the data size is determined by the following flags:
.b This is for data in 8-bit bytes.
.w This is for data in 16-bit words.
.l This is for data in 32-bit long words.
These flags are optional arguments and describe the objects on which the command oper-
ates. If you do not specify a flag, memory commands default to 32-bit long words. Numeric
arguments are in hexadecimal.