Filter
Top Products
Setup: Katana®752i Circuit Board
10006024-04 Katana
®
752i User’s Manual
2-5
Figure 2-4: Jumper, Fuse, and Switch Locations, Top
COPYRIGHT 2004
10006008-00 REV A
F4
F3
F1
F2
J3J4J5
J22
J21
J24
J23
J12
J11
J1J2
J14
J13
P1
CR1
P2
JP2
JP1
SW1
SW1 Reset Switch
F4 Fuse
for 5-Volt Supply to RTM, 2.5A
F3 Fuse
for 3.3-Volt Supply to RTM, 2.5A
F2 Fuse
for 12-Volt Supply to RTM, 1A
F1 Fuse
for +12-Volt Supply to RTM, 1A
JP1 Signal Enable Jumpers
(pins 109 are spares)
Jumper on pins 8 & 7, cPCI enabled
Jumper on pins 6 & 5, PCIXCAP enabled
Jumper on pins 4 & 3, CT_EN enabled
Jumper on pins 2 & 1, cPCI_RST enable
Note: To enable cPCI functionality, use a
jumper on pins 8-7 and on pins 2-1.
JP2 Configuration Jumpers
Jumpers off pins 107, MV64460 is Monarch
Jumper on pins 10 & 9, PPMC #2 is Monarch
Jumper on pins 8 & 7, PPMC #1 is Monarch
Jumper on pins 6 & 5, enable cPCI_PRST out
Jumper on pins 4 & 3, disable SROM load
Jumper on pins 2 & 1, boot from socket
12
34
56
78
910
12
34
56
78
910