Monitor: Other Commands
Katana®752i User’s Manual 10006024-04
15-26
Setting PCI Mode to Multi ... Complete
=>
setspr
The setspr command sets the contents of the SPR register specified by SPR_ID to
SDR_Value.
Definition:
setspr SPR_ID SPR_Value
script
The script command runs a list of monitor commands out of memory. The list is an ASCII
string of commands separated by the
; character and terminated with the ;; charac-
ter sequence. <script address> is the starting location of the script.
Definition:
script script_address
showmac
The showmac command displays the Processor MAC addresses.
Definition:
showmac
showpci
The showpci command scans the PCI bus and lists the base address of the devices.
Definition:
showpci
showtemp
The showtemp command continuously displays the junction temperature for the 750GL
CPU. The processor sensors are not calibrated, so some offset error is probable.
Definition:
showtemp
sleep
The sleep command executes a delay of N seconds.
Definition: Delay execution for N seconds (N is a decimal value).
sleep N
vdhcp
The vdhcp command sends out a DHCP request and then waits for the response from a
DHCP server. If available, a vendor-specific module (loaded at 0xFFF6,8000) processes vari-
ous request/response options.
Definition:
vdhcp