Filter
Top Products
Monitor: Other Commands
10006024-04 Katana®752i User’s Manual
15-25
Modify, read, and keep the CFG address.
pci next[.b, .w, .l] b.d.f address
Modify automatically increment the CFG address.
pci modify[.b, .w, .l] b.d.f address
Write to the CFG address.
pci write[.b, .w, .l] b.d.f address value
reset
The reset command performs a hard reset of the CPU by writing to the reset register on the
board.
Definition:
reset
run
The run command runs the commands in an environment variable var.
Definition:
run var […]
setpcimemsize
The getpcimemsize command stores a user-defined memory window size for PCI/cPCI to
NVRAM. These window sizes define the amount of memory that can be accessed from a
PCI/cPCI device. Parameters can be
all, default or a numerical value, num. The default
values are 0x80000000 for cPCI,
all for PCI Monarch, and one gigabyte for PCI Non-
Monarch. These are written into NVRAM as 0xFFFFFFFF for the monitor to set defaults.
Changes take effect on reset.
Definition:
setpcimemsize cpci_memsize pci_memsize (all,default,num)
Example: =>setpcimemsize 0x80000000 default
Writing NVRAM parameters CPCI:0x80000000, PCI:0xFFFFFFFF
... Success
=>
setpcimode
The setpcimode command stores a user-defined setting for the supported configuration
space headers. You can select single or multiple headers for both PCI and cPCI. The default
settings are
cPCI Single Mode and PCI Multi Mode. Changes take effect on
reset.
Definition:
setpcimode cpci_mode pci_mode (single, multi, default)
Example: =>setpcimode
Setting cPCI Mode to Single ...