Filter
Top Products
Monitor: Test Commands
Katana®752i User’s Manual 10006024-04
15-20
TEST COMMANDS
The commands described in this section perform diagnostic and memory tests.
diags
The diags command runs the power-on self test (POST).
Definition:
diags
mtest
The mtest command performs a simple SDRAM read/write test.
Definition:
mtest [start [end [pattern]]]
um
The um command is a destructive memory test.
Definition:
um [.b, .w, .l] base_addr [top_addr]
OTHER COMMANDS
This section describes all the remaining commands supported by the Katana®752i moni-
tor.
autoscr
The autoscr command runs a script, starting at address addr, from memory.
A valid autoscr header must be present.
Definition:
autoscr [addr]
base
The base command prints or sets the address offset for memory commands.
Definition: Displays the address offset for the memory commands.
base
Sets the address offset for the memory commands to off.
base off
bdinfo
The bdinfo command displays the Board Information Structure.
Definition:
bdinfo