Filter
Top Products
Setup: Katana®752i Circuit Board
Katana
®
752i User’s Manual 10006024-04
2-8
J4 : J4 is a 90-pin connector that routes computer telephony (CT) bus signals to the Compact-
PCI backplane. See Chapter for pinouts.
J5: J5 is a 110-pin connector that routes user input/output signals directly from the J24 connec-
tor at PTMC expansion site #2. It also routes optional RMII signals from both PTMC sites. See
Chapter for pinouts.
J6: J6 is a 3-pin header on the circuit board for the ejector switch (for factory use only).
J7: J7 is a 10-pin header on the circuit board that provides an in-system programmable (ISP)
JTAG interface to the programmable logic (PLD) devices (factory use only).
J11—J14: J11, J12, J13, and J14 are 64-pin connectors that support PTMC expansion site #1. See
Table 9-1 for pinouts.
J21—J24: J21, J22, J23, and J24 are 64-pin connectors that support PTMC expansion site #2. See
Table 9-2 for pinouts.
Fuses
There are seven fuses on the Katana
®
752i circuit board.
Note: The part numbers for these fuses are subject to change. Please check with Emerson before ordering replace-
ment fuses.
F1—F2: These 1-amp fuses (see Fig. 2-4) protect the ±12-volt power supplies. They are Emerson part
number 02739005-00.
F3—F4: These surface-mounted, socketed, 2.5-amp fuses (see
Fig. 2-4) protect the 3.3-volt and 5-
volt power supplies. They are Emerson part number 02959021-00.
F5—F7: These 0.75 amp fuses (see
Fig. 2-5) protect the power supplies for the COP/JTAG interface
(P3) and PLD header (J7). They are Emerson part number 02959012-00.
LEDs
The Katana
®
752i has various light-emitting diodes (LEDs), as described in the following
table. Please refer to
Fig. 2-1 and Fig. 2-5 to locate these LEDs.
Table 2-2: LEDs
LED: Color: Signal Name: Comments:
CR1 Blue HOTSWAP_LED* front panel Hot Swap status
CR2 Red PWRLED_OUT front panel Fault LED
CR31 750GL_CHKSTP_OUT* CPU checkstop indicator