Filter
Top Products
IPMI Controller: IPMI Message Protocol
10006024-04 Katana
®
752i User’s Manual
11-9
IPMI Completion Codes
All IPMI response messages contain a hexadecimal Completion Code field that indicates the
status of the operation.
Table 11-7 lists the Completion Codes (as defined in the IPMI specifi-
cation) used by the Zircon PM.
Table 11-7: Completion Codes
Code: Description:
Generic Completion Codes 00, C0-FF
00 Command completed normally
C0 Node busy–command could not be processed because command-processing
resources are temporarily unavailable
C1 Invalid command–indicates an unrecognized or unsupported command
C2 Command invalid for given LUN
C3 Time-out while processing command, response unavailable
C4 Out of space–command could not be completed because of a lack of storage
space required to execute the given command operation
C5 Reservation canceled or invalid Reservation ID
C6 Request data truncated
C7 Request data length invalid
C8 Request data field length limit exceeded
C9 Parameter out of range–one or more parameters in the data field of the Request
are out of range. This is different from Invalid data field code (CC) because it
indicates that the erroneous field(s) has a contiguous range of possible values.
CA Cannot return number of requested data bytes
CB Requested sensor, data, or record not present
CC Invalid data field in Request
CD Command illegal for specified sensor or record type
CE Command response could not be provided
CF Cannot execute duplicated request–for devices that cannot return the response
returned for the original instance of the request. These devices should provide
separate commands that allow the completion status of the original request to be
determined. An Event Receiver does not use this completion code, but returns the
00 completion code in the response to (valid) duplicated requests.
D0 Command response could not be provided, SDR Repository in update mode
D1 Command response could not be provided, device in firmware update mode
D2 Command response could not be provided, BMC initialization or initialization
agent in progress
D3 Destination unavailable–cannot deliver request to selected destination. (This
code can be returned if a request message is targeted to SMS, but receive
message queue reception is disabled for the particular channel.)
D4 Cannot execute command, insufficient privilege level
D5 Cannot execute command, parameter(s) not supported in present state
FF Unspecified error