Filter
Top Products
PTMC Interface: PTMC Installation
Katana
®
752i User’s Manual 10006024-04
9-2
The following procedure describes how to attach a PTMC module to the Katana
®
752i base-
board:
1 Remove the screws from the standoffs on the PTMC module.
2 Hold the module at an angle and gently slide the faceplate into the opening on the
baseboard.
3 Align the P11, P12, P13, and P14 connectors and gently press the module into place until
firmly mated.
Caution: To avoid damaging the module and/or baseboard, do not force the module onto the
baseboard.
4 Using four M2.5x6mm flathead screws, secure the PTMC module from the bottom of the
baseboard. First, insert and tighten the screws closest to the P11, P12, P13, and P14
connectors. Next, insert and tighten the screws nearest to the front panel.
!
Tighten these two screws first.
PTMC1
PTMC2
P11
P12
J11
J12
J14
J13
PTMC Module
P13
P14
J21
J22
J23
J24