Filter
Top Products
10. Highlight the mode by moving the cursor with the ↑ or ↓ key, and then print the current Bi-d
print alignment pattern for that mode by pressing SPACE.
11. If the Bi-d pattern is not aligned properly, adjust it by changing the value with the ← or → key.
If the second row is shifted to the right of the first row, change the value by pressing the ← key,
and print the new Bi-d print alignment pattern by pressing SPACE. If the second row is shifted to
the left of the first row, change the value by pressing the → key, and print the new Bi-d print
alignment pattern by pressing SPACE. Perform this operation for each mode (0, 1, and 2).
12. When the Bi-d print alignment is correct for each print mode, press ENTER to write the
adjusted values to the EEPROM and print the adjusted value for each mode. This operation
returns the program to the Main Menu automatically.
13. To exit this program, press ESC until the computer returns to the MS-DOS prompt.
The factory settings are written to the EEPROM when you run one of the the check programs,
shown in the Main Menu. After you select the factory settings, be sure to run the check program.
< Bi-d adjustment >
> Mode 0 = 0
Mode 1 = 0
Mode 2 = 0
Cancel Print Speed Value Write Default
[ ESC ] [ SPACE ] [ ] [ ] [ RET ] [ HOME ]
Figure 4-8 Bi-d Adjustment Menu
Mode 0 VR0 = 0
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
Figure 4-9 Current Bi-d Print Alignment
FX-2170 Service Manual Adjustment
Rev. A 4-5