Filter
Top Products
4.2.4 TPE Level Reset
This section describes the procedure to reset the TPE (top paper end) level. This operation is required when
the PW sensor assembly is replaced, and if it is not performed, the printer does not recognize that the PW
sensor has been replaced, thus, limiting the ability of the new sensor to operate. This reset operation can be
performed only from the Settings Diskette.
Note:
•
After this operation, the reset value for the TPE LEVEL is printed out automatically.
Check that the reset value is
FF
.
1. Insert the Settings Diskette into Drive A of the PC, and turn the power on.
2. Type GWBASIC and press ENTER.
3. Load and run the J10A00E program. First, the Machine Select Menu is displayed.
4. In this menu, highlight 9 pins by moving the cursor with ↑ or ↓ key, and select it by pressing
ENTER.
5. After you select 9 pins, the Setting File menu is displayed.
6. In this menu, highlight the destination factory settings by moving the cursor with ↑ or ↓ key,
and select the factory settings by pressing ENTER.
7. After you select the factory settings, the Main Menu is displayed.
8. In this menu, highlight TPE LEVEL RESET by moving the cursor with ↑ or ↓ key and select it by
pressing ENTER. This operation prints the reset value of the TPE LEVEL automatically. The reset
value should be FFH. Check that the reset value is FFH.
9. To exit the program, press ESC until the display returns to the MS-DOS prompt.
Program : J10A00E Setting : DEFSTD
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Printer select ]
> (1) 9 pins
(2) 24 pins
Figure 4-14 Machine Select Menu
Program : J10A00E Setting : DEFSTD
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Setting File ]
> (1) DEFSTD
(2) EURSTD
(3) NLSP
(4) ITALIC
(5) RUSSIAN
Figure 4-15 Setting File Menu
Program : J10A00E Setting : DEFSTD
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Main MENU ]
(1) Bi-d Adjust > (6) TPE LEVEL RESET
(2) Check Pro. (FF)
(3) Check Pro. (A3)
(4) Check Pro. (A4)
(5) Check Pro. (Envelope)
Figure 4-16 Main Menu
Adjustment FX-2170 Service Manual
4-8 Rev.A