Filter
Top Products
Configuring IP
The show ip cache command displays the following information.
Table 6.14: CLI Display of IP Forwarding Cache – routing switch
This Field... Displays...
IP Address The IP address of the destination.
Next Hop The IP address of the next-hop router to the destination. This field
contains either an IP address or the value DIRECT. DIRECT means
the destination is either directly attached or the destination is an
address on this HP device. For example, the next hop for loopback
addresses and broadcast addresses is shown as DIRECT.
MAC The MAC address of the destination.
Note: If the entry is type U (indicating that the destination is this HP
device), the address consists of zeroes.
Type The type of host entry, which can be one or more of the following:
• D – Dynamic
• P – Permanent
• F – Forward
• U – Us
• C – Complex Filter
• W – Wait ARP
• I – ICMP Deny
• K – Drop
• R – Fragment
• S – Snap Encap
Port The port through which this device reaches the destination. For
destinations that are located on this device, the port number is shown
as “n/a”.
VLAN Indicates the VLAN(s) the listed port is in.
Pri The QoS priority of the port or VLAN.
USING THE WEB MANAGEMENT INTERFACE
To display the IP forwarding cache:
1. Log on to the device using a valid user name and password for read-only or read-write access. The System
configuration panel is displayed.
2. Click on the plus sign next to Monitor in the tree view to list the monitoring options.
3. Click on the plus sign next to IP to list the IP monitoring options.
4. Click on the Cache
link to display the IP cache.
6 - 89