Filter
Top Products
-------------------------------
Configuring IP Multicast Protocols
Candidate-RP-advertisement period Indicates how frequently the BSR sends candidate RP advertisement
messages.
Note: This field appears only if this routing switch is a candidate RP.
This Field... Displays...
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
Displaying RP-to-Group Mappings
To display RP-to-group mappings, use the following CLI method.
USING THE CLI
To display RP-to-group-mappings, enter the following command at any CLI level:
HP9300(config-pim-router)# show ip pim rp-map
Group address RP address
239.255.162.1 207.95.7.1
Syntax: show ip pim rp-map
This display shows the following information.
This Field... Displays...
Group address Indicates the PIM Sparse multicast group address using the listed RP.
RP address Indicates the IP address of the Rendezvous Point (RP) for the listed
PIM Sparse group.
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
Displaying RP Information for a PIM Sparse Group
To display RP information for a specific PIM Sparse group, use the following CLI method.
USING THE CLI
To display RP information for a PIM Sparse group, enter the following command at any CLI level:
HP9300(config-pim-router)# show ip pim rp-hash 239.255.162.1
RP: 207.95.7.1, v2
Info source: 207.95.7.1, via bootstrap
Syntax: show ip pim rp-hash <group-addr>
The <group-addr> parameter is the address of a PIM Sparse IP multicast group.
9 - 23