Filter
Top Products
Configuring VRRP and VRRPE
Table 12.3: CLI Display of VRRP or VRRPE Detailed Information (Continued)
state This routing switch’s VRRP or VRRPE state for the VRID. The state
can be one of the following:
• initialize – The VRID is not enabled (activated). If the state
remains “initialize” after you activate the VRID, make sure that
the VRID is also configured on the other routers and that the
routers can communicate with each other.
Note: If the state is “initialize” and the mode is incomplete, make
sure you have specified the IP address for the VRID.
• backup – This routing switch is a Backup for the VRID.
• master – This routing switch is the Master for the VRID.
administrative-status The administrative status of the VRID. The administrative status can
be one of the following:
• disabled – The VRID is configured on the interface but VRRP or
VRRPE has not been activated on the interface.
• enabled – VRRP or VRRPE has been activated on the interface.
mode Indicates whether the routing switch is the Owner or a Backup for the
VRID.
Note: If “incomplete” appears after the mode, configuration for this
VRID is incomplete. r example, you might not have configured the
virtual IP address that is being backup up by the VRID.
Note: s field applies only to VRRP. uting switches configured
for VRRPE are Backups.
priority The device’s preferability for becoming the Master for the VRID.
During negotiation, the router with the highest priority becomes the
Master.
If two or more devices are tied with the highest priority, the Backup
interface with the highest IP address becomes the active router for the
VRID.
current priority The current VRRP or VRRPE priority of this routing switch for the
VRID. e current priority can differ from the configured priority (see
the row above) for the following reasons:
• The VRID is still in the initialization stage and has not become a
Master or Backup yet. n this case, the current priority is 0.
• The VRID is configured with track ports and the link on a tracked
interface has gone down. e “Track Ports and Track Priority” on
page 12-5.
hello-interval The number of seconds between Hello messages from the Master to
the Backups for a given VRID.
This Field... Displays...
Fo
Thi All ro
Th
I
Se
12 - 23