Filter
Top Products
Configuring AppleTalk
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Enable radio button next to AppleTalk.
3. Click the Apply button to apply the changes to the device’s running-config file.
4. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
Configuring a Seed AppleTalk Router
When you configure an AppleTalk router as a seed router, you must define the cable range, AppleTalk address,
and zone names for the router interfaces.
To configure a seed router, perform the following tasks:
1. Configure the cable range (network numbers) to be supported on that interface.
2. Assign an AppleTalk address to the interface.
3. Assign a zone or zones to the interface.
4. Enable AppleTalk routing on the interface.
NOTE: Before configuring interface parameters for AppleTalk, you must enable AppleTalk at the system level.
USING THE CLI
This section describes defining a cable range, assigning network addresses and zones, and enabling AppleTalk
routing on an interface.
Configuring the Cable Range for an Interface
To support network numbers from 10 – 50 on interface 1/3, enter the following commands:
HP9300(config)# int e 1/3
HP9300(config-if-1/3)# appletalk cable 10 - 50
Syntax: appletalk cable <network-number> | <network-number – network-number>
Configuring a Network Address for an Interface
To assign an AppleTalk address of 10.5 to interface 1/3, enter the following command:
HP9300(config-if-3)# appletalk address 10.5
Syntax: appletalk address <node.network>
Configuring Zones on an Interface
To assign sales, marketing, and finance zones for interface 1/3, enter the following commands:
HP9300(config-if-1/3)# appletalk zone sales
HP9300(config-if-1/3)# appletalk zone marketing
HP9300(config-if-1/3)# appletalk zone finance
NOTE: You can configure up to 1536 zones on a routing switch.
Enabling AppleTalk Routing on an Interface
To enable AppleTalk routing on interface 1/3, enter the following command:
HP9300(config-if-1/3)# appletalk routing
15 - 5