Filter
Top Products
Advanced Configuration and Management Guide
Here is an example for a VRRPE Backup.
HP9300(config)# show ip vrrp-extended
Total number of VRRP-Extended routers defined: 1
Interface ethernet 1/6
auth-type no authentication
VRID 1
state master
administrative-status enabled
priority 200
current priority 200
hello-interval 1 sec
dead-interval 3.600 sec
current dead-interval 3.600 sec
preempt-mode true
virtual ip address 192.53.5.254
advertise backup: enabled
master router 192.53.5.2 expires in 00:00:03
track-port 2/4
Syntax: show ip vrrp brief | ethernet <portnum> | ve <num> | stat
Syntax: show ip vrrp-extended brief | ethernet <portnum> | ve <num> | stat
The brief parameter displays summary information. See “Displaying Summary Information” on page 12-19.
The ethernet <portnum> parameter specifies an Ethernet port. If you use this parameter, the command displays
VRRP or VRRPE information only for the specified port.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command displays VRRP or
VRRPE information only for the specified virtual interface.
The stat parameter displays statistics. See “Displaying Statistics” on page 12-26.
This display shows the following information.
Table 12.3: CLI Display of VRRP or VRRPE Detailed Information
This Field... Displays...
Total number of VRRP (or VRRP-
Extended) routers defined
The total number of VRIDs configured on this routing switch.
Note: The total applies only to the protocol the routing switch is
running. For example, if the routing switch is running VRRPE, the
total applies only to VRRPE routers.
Interface parameters
Interface The interface on which VRRP or VRRPE is configured. If VRRP or
VRRPE is configured on multiple interfaces, information for each
interface is listed separately.
auth-type The authentication type enabled on the interface.
VRID parameters
VRID The VRID configured on this interface. If multiple VRIDs are
configured on the interface, information for each VRID is listed
separately.
12 - 22