Filter
Top Products
Installation and Getting Started Guide
Syntax: show ipx interface [ethernet <portnum> | ve <num>]
The ethernet <portnum> parameter lets you specify a routing switch port.
The ve <num> parameter lets you specify a virtual interface (VE).
This display shows the following information.
Table 14.2: CLI Display of IPX Interface Information
This Field... Displays...
Interface The port or virtual interface on which the IPX interface is configured.
MAC address The MAC address of the interface.
Port state The state of the interface. The state can be one of the following:
• DOWN
• UP
IPX network The IPX network number.
Frame type The frame type of the network. The frame type can be one of the
following:
• ethernet_802.2
• ethernet_802.3
• ethernet_ii
• ethernet_snap
Allow NetBIOS Indicates whether the interface allows NetBIOS traffic. This field can
have the following values:
• NO
• YES
rip-interval The RIP advertisement interval. e RIP advertisement interval
specifies how often the routing switch sends IPX RIP updates to
neighboring IPX routers.
To modify this parameter, see “Modify the RIP Advertisement Interval”
on page 14-14.
rip-max-packet-size The maximum packet size for IPX RIP updates. The default IPX RIP
packet size is 432 bytes, which allows 50 routes plus 32 bytes of
header in an IPX RIP update packet.
To modify this parameter, see “Modify the RIP Advertisement Packet
Size” on page 14-13.
rip-multiplier The age timer for learned IPX routes. The age timer specifies how
many seconds a learned IPX route can remain in the routing switch's
IPX route table before aging out.
To modify this parameter, see “Modify the Age Timer for Learned IPX
Routes” on page 14-15.
Th
14 - 18