Filter
Top Products
Configuring VLANs
Modifying a Port-Based VLAN
You can make the following modifications to a port-based VLAN:
• Add or delete a VLAN port.
• Change its priority.
• Enable or disable STP.
Removing a Port-Based VLAN
Suppose you want to remove VLAN 5 from the example in Figure 16.10. To do so, use the following procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on 6208M-SX A by entering the following commands:
HP6208-A> enable
No password has been assigned yet...
HP6208-A# configure terminal
HP6208-A(config)#
2. Enter the following command:
HP6208-A(config)# no vlan 5
HP6208-A(config)#
3. Enter the following commands to exit the CONFIG level and save the configuration to the system-config file
on flash memory:
HP6208-A(config)#
HP6208-A(config)# end
HP6208-A# write memory
HP6208-A#
4. Repeat steps 1 – 3 on 6208M-SX B.
Syntax: no vlan <vlan-id> by port
Removing a Port from a VLAN
Suppose you want to remove port 11 from VLAN 4 on 6208M-SX A shown in Figure 16.10. To do so, use the
following procedure.
USING THE CLI
1. Access the global CONFIG level of the CLI on 6208M-SX A by entering the following command:
HP6208-A> enable
No password has been assigned yet...
HP6208-A# configure terminal
HP6208-A(config)#
2. Access the level of the CLI for configuring port-based VLAN 4 by entering the following command:
HP6208-A(config)#
HP6208-A(config)# vlan 4
HP6208-A(config-vlan-4)#
3. Enter the following commands:
HP6208-A(config-vlan-4)#
HP6208-A(config-vlan-4)# no untag ethernet 11
deleted port ethe 11 from port-vlan 4.
HP6208-A(config-vlan-4)#
16 - 17