Filter
Top Products
12. Using NDIS 165
Make sure that all of these components are installed, and determine the correct
configuration options for the client software. Windows 95 only enables one Dial-
Up Networking connection to be active at a time. In the following configuration
example, the NetBEUI protocol from Microsoft is used to map a folder on the
remote server hard disk drive to a network drive on the client computer, enabling
the client to access the remote folder over ISDN as if it were a local hard disk
drive.
RAS configuration example
(Local Site: Windows 95 computer; Remote Site: Windows 95 computer; both
equipped with ISDN adapters)
Preparations (client and server):
To prepare your client and server, do the following:
1. Install the Dial-Up Server (on the server only)
For a Windows 95 computer to operate as a RAS server, the file
RNASERV.DLL must be present in the \WINDOWS\SYSTEM directory. This
file is usually installed with the MS ISDN Accelerator Pack 1.1, but can also be
installed from the Windows 95 Plus Pack. If this DLL is present, then the
command “Dial-Up Server” opens in the Connections menu of the Dial-Up
Networking window.
2. Install the NetBEUI protocolby doing the following:
Click Control Panel -> Network -> Add... -> Protocol -> Add... ->
Manufacturer: “Microsoft” -> NetBEUI.
3. Check the protocol binding by doing the following:
Click Control Panel -> Network -> Dial-Up Adapter -> Properties ->
“Bindings” tab -> NetBEUI” must be active
4. Install the client by doing the following:
Click Control Panel -> Network -> Add... -> Client -> Add... ->
Manufacturer: “Microsoft” -> Client for Microsoft Networks
5. Install File and Print Sharing (on the server only) by doing the following:
Click Control Panel -> Network -> Add... -> Service -> Add... ->
Manufacturer: select “Microsoft”-> File and print sharing for Microsoft
Networks
Configuring the Windows 95 server
Configure the Windows 95 server by doing the following:
1. Define the computer name by doing the following:
Click Control Panel -> Network -> Identification. Computer name. Type a
name for the computer.
Example: SERVER
2. Activate file and print sharing by doing the following:
ISDNmst.fm Page 165 Wednesday, January 15, 2003 9:22 AM