Filter
Top Products
13. ISDN CAPI Port Device Driver 187
dealer or Microsoft. In order to use Windows 95/98 RAS over ISDN, the
following components must be installed:
• ISDN-Controller
• CAPI device drivers (installed during the ISDN-Controller Setup)
• ISDN CAPI Port Device Driver
• Dial-Up Networking (and Dial-up Server module, if desired)
• ·Network protocol with appropriate client software (such as NetBEUI), bound
to the Dial-up Adapter.
Make sure that all of these components are installed.
Note that Windows 95/98 can use only one Dial-up Networking connection at a
time.
In the following example configuration, the Microsoft NetBEUI protocol is used to
”map” a drive on the remote computer to the local computer, so that the remote
drive can be addressed as a local drive over ISDN.
Example RAS configuration (Windows 95/98 computer to Windows 95/98
computer using ISDN controllers): Preparations (client and server)
1. Install Dial-Up Networking server module (server computer only)
2. In order to provide RAS services from a Windows 95 computer, the file
RNASERV.DLL must be contained in the Windows\System folder. This file
can be installed from the Windows 95 Plus Pack. It is already included in
certain Windows 95 release versions, and can be extracted from the
compressed installation files on the original Windows 95 disk using the
command EXTRACT /E WIN95_06.CAB RNASERV.DLL.
3. Windows 98 users must install the Dial-Up Networking server module
via:Start -> Settings -> Control Panel -> Software -> Windows Setup ->
Communications -> Details... -> Dial-Up Networking
4. Install the NetBEUI protocol: Start -> Settings -> Control Panel -> Network -
> Add... -> Protocol -> Add... -> Microsoft -> NetBEUI -> OK
5. Verify protocol binding: Start -> Settings -> Control Panel -> Network ->
Dial-Up Adapter -> Properties -> Bindings. NetBEUI must be selected.
6. Install client: Start -> Settings -> Control Panel -> Network -> Add... ->
Client -> Add... -> Microsoft -> Client for Microsoft networks -> OK.
7. Install File and Print Sharing (server only): Start -> Settings -> Control Panel
-> Network -> Add... -> Service -> Add... Microsoft -> File and print sharing
for Microsoft networks -> OK.
Configuring the Windows 95/98 client:
1. Create a new Dial-Up Networking connection: My Computer -> Dial-Up
Networking -> Make New Connection. Enter a name for the connection.
Select modem ISDN RAS (PPP over ISDN) and click Continue. Enter the
phone number (when dialing from a PBX extension, remember to include the
outside line prefix). Click Continue and then Finish.
ISDNmst.fm Page 187 Wednesday, January 15, 2003 9:22 AM