Filter
Top Products
7. Installing the device drivers in Windows NT 4.0 41
5. In the next window you must select a COM port to be assigned to the modem.
Select a port and click Next. You are then asked to type your location
information: the country you are in, the area code, and other details. Fill in the
text fields and click Next. In the last window, click Finish.
6. The Dial-Up Networking installation now displays the Add RAS Device
window. In the example illustrated below, the RAS device is the Dial-Up
Networking Serial Cable between 2 PCs on COM 2. Click OK.
7. The selected device is now displayed in the Setup window. Click Continue.
Remote Access Setup informs you that no networking protocols have been
installed. Click OK. In the Network Configuration window, select the
network protocols you want to use. The TCP/IP protocol is usually sufficient.
Click OK.
8. Now click Continue again. When you are prompted to restart your computer,
click Do Not Restart. Instead, reinstall the current Service Pack before
restarting. This will help you to avoid problems afterwards.
ISDNmst.fm Page 41 Wednesday, January 15, 2003 9:22 AM