Filter
Top Products
CTI 2572 Installation and Operation Guide
97
HEX DEC DESCRIPTION SOLUTION
00A8 168 DUPLICATE CONNECTION NUMBER
An attempt was made to start two protocol
managers with the same connection number.
Check the Command Blocks for the
respective Create Connection
commands.
Ensure that the Create Connection
commands use different connection
numbers.
00A9 169 INVALID PROTOCOL MGR NUMBER
You entered an invalid protocol manager
number in the Command Block.
Review the documentation and correct
the command block.
00AA 170 INVALID PORT NUMBER
An attempt was made to start a protocol
manager with an invalid physical port number
for serial ports.
This can also occur when you specify an
invalid serial port number for the Serial
Redirect Command.
This error will occur if you enter an
invalid physical port number in the
command block. Valid physical port
numbers for the 2572 serial ports are
1 or 2.
Correct the command block and retry
the command.
00AE 174 NETWORK NOT INITIALIZED
You attempted to execute a C
REATE SOCKET
command before the 2572 network server has
been started.
If you are using the PLC Start option,
the Start Network Server command
was not executed successfully.
Check for the proper execution of this
command including the command
block and PLC logic for this
command.
If you are using the AutoStart option,
ensure that the network parameters
are properly stored in EEPROM. You
can use the CTI IPSET program to
examine this.
00AF 175 EEPROM WRITE PROTECT WARNING
The EEPROM Write Protect switch is ON.
You cannot write to the EEPROM
If you want to write the EEPROM, set
the EEPROM Write Protect switch to
OFF.
00B0 176 EEPROM HARDWARE WRITE ERROR
The 2572 was unable to write data to the
EEPROM
Retry. If the problem persists, replace
the module.
00B1 177 EEPROM HARDWARE READ ERROR
The 2572 was unable to read data from the
EEPROM
Retry. If the problem persists, replace
the module.
00B2 178 INVALID V MEMORY ADDRESS
The Command Block contained a V memory
address of 0.
Correct the Command Block data.
00B3 179 INSUFFICIENT V MEMORY RESERVED
You failed to reserve enough V memory to
hold the data returned by the command.
Correct the Command Block data.