Filter
Top Products
CTI 2572 Installation and Operation Guide
103
237C 9084 BAD BCC - CAMP PROTOCOL
The 2572 received a CAMP message with
bad Block Check Character field.
This error is for information only.
See error 237A above
237D 9085 INVALID TYPE CODE -CAMP PROTOCOL
The 2572 received a CAMP message which
contained an invalid Type Code.
This error is for information only.
See error 237A above
237E 9086 INVALID CHARACTER - CAMP PROTOCOL
The 2572 received a CAMP message which
contained an invalid character.
This error is for information only.
See error 237A above.
237F 9087 ODD CHARACTER COUNT - CAMP
The 2572 received a CAMP message which
did not contain an even number of characters.
This error is for information only.
See error 237A above.
2380 9088 INVALID ERROR CHARACTER - CAMP
The 2572 received a CAMP message which
contained an unsupported error character.
This error is for information only.
See error 237A above.
2381 9089 NO DATA - CAMP PROTOCOL
The 2572 received a CAMP write message
which contained no data.
This error is for information only.
See error 237A above.
2382 9090 WORD COUNT ERROR - CAMP
The 2572 received a CAMP message in which
the number of words did not match the word
count field.
This error is for information only.
See error 237A above.
2383 9091 INVALID MEMORY ADDRESS - CAMP
The 2572 received a CAMP message which
specified a memory address not supported by
the PLC.
This error is for information only.
See error 237A above.
2386 9094 INVALID IP ADDRESS
The Start Network Server command block
does not contain a valid local IP address.
You cannot use a value of 0000 hex or greater
than DFFF hex for the IP address. Correct
the entry and retry the command.
2387 9095 INVALID PORT NUMBER
The Start Network Server command block
contains a value of 0 for the PLC server
TCP/UDP port number.
You must select a number greater than 0.
2388 9096 INVALID DEFAULT ROUTER ADDRESS
The Start Network Server command block
contains an invalid address for the default
router.
Correct the entry and retry the command.
Note: If you do not have a router on the
network, set this value to 0.