Filter
Top Products
Functional Architecture Intel® Server Board SE7520JR2
Revision 1.0
C78844-002
28
3.1.5 Common Enabling Kit (CEK) Design Support
The baseboard has been designed to comply with Intel’s Common Enabling Kit (CEK)
processor mounting and heat sink retention solution. The baseboard will ship with a CEK spring
snapped onto the bottom side of the board beneath each processor socket. The CEK spring is
removable, allowing for the use of non-Intel heat sink retention solutions.
Figure 4. CEK Processor Mounting
3.1.6 Processor Support
The Server Board SE7520JR2 is designed to support one or two Intel® Xeon™ processors
utilizing an 800 MHz front side bus with frequencies starting at 2.8 GHz. Previous generations of
Intel Xeon processor are not supported on the Server Board SE7520JR2.
The server board is designed to provide up to 120A peak per processors. Processors with
higher current requirements are not supported.
Note: Only Intel
®
Xeon™ processors that support an 800MHz Front Side Bus are supported on
the Server Board SE7520JR2. See the following table for a list of supported processors and
their operating frequencies.
Table 2: Processor Support Matrix
Processor Family FSB Frequency Frequency Support
Intel® Xeon™ 533 MHz 2.8 GHz No
Intel® Xeon™ 533 MHz 3.06 GHz No
Intel® Xeon™ 533 MHz 3.2 GHz No
Intel® Xeon™ 800 MHz 2.8 GHz Yes
Intel® Xeon™ 800 MHz 3.0 GHz Yes
Heatsink assembly with
inte
g
rated hardware
Thermal Interface
Material (TIM)
Baseboard
CEK Spring
Chassis