Filter
Top Products
Intel® Server Board SE7520JR2 Functional Architecture
Revision 1.0
C78844-002
29
Processor Family FSB Frequency Frequency Support
Intel® Xeon™ 800 MHz 3.2 GHz Yes
Intel® Xeon™ 800 MHz 3.4 GHz Yes
Intel® Xeon™ 800 MHz 3.6 GHz Yes
3.1.6.1 Processor Mis-population Detection
The processors must be populated in the correct order for the processor front-side bus to be
correctly terminated. CPU socket 1 must be populated before CPU socket 2. Baseboard logic
will prevent the system from powering up if a single processor is present but it is not in the
correct socket. This protects the logic against voltage swings or unreliable operation that could
occur on an incorrectly terminated front-side bus.
If processor mis-population is detected when using standard on-board platform instrumentation,
the mBMC will log an error against processor 1 to the System Event Log; Configuration Error,
and the baseboard hardware will illuminate both processor error LEDs. If an IMM (Professional
or Advanced editions) is used in systems, the Sahalee BMC will generate a series of beep
codes when this condition is detected and the BMC will illuminate the processor 1 fault LED.
3.1.6.2 Mixed Processor Steppings
For optimum system performance, only identical processors should be installed in a system.
Processor steppings within a common processor family can be mixed in a system provided that
there is no more than a 1 stepping difference between them. If the installed processors are
more than 1 stepping apart, an error is reported. Acceptable mixed steppings are not reported
as errors by the BIOS.
3.1.6.3 Mixed Processor Models
Processor models cannot be mixed in a system. If this condition is detected an error (8196) is
logged in the SEL. An example of a faulty processor configuration may be when one installed
processor supports a 533MHz front side bus while the other supports an 800MHz front side bus.
3.1.6.4 Mixed Processor Families
Processor families cannot be mixed in a system. If this condition is detected an error (8194) is
logged in the SEL.
3.1.6.5 Mixed Processor Cache Sizes
If the installed processors have mixed cache sizes, an error (8192) will be logged in the SEL
and an error (196) is reported to the Management Module. The size of all cache levels must
match between all installed processors. Mixed cache processors are not supported.
3.1.6.6 Jumperless Processor Speed Settings
The Intel
®
Xeon
TM
processor does not utilize jumpers or switches to set the processor
frequency. The BIOS reads the highest ratio register from all processors in the system. If all
processors are the same speed, the Actual Ratio register is programmed with the value read
from the High Ratio register. If all processors do not match, the highest common value between