Filter
Top Products
Integrator’s Reference Manual
6-2 80-99208-1 Rev. D
• Special Calls and Services Commands (page 6-64)
• Protocol Stack Modification Commands (page 6-70)
Note
For details about AT commands supported by the GSP-1600 Tri-Mode
Phone, see the QUALCOMM Globalstar Data User Guide (80-99126-1).
AT Command Quick Reference Tables
For many commands listed in Table 6-1 and Table 6-2, the
entries for “Value Range,” “No Value Definition,” or
“Power-On/Reset Default” have no valid value. These entries
have different symbols in place of values:
• A dash “-” character means that, for this command, the
value is either not present or not allowed.
• A caret “^” character means that no current value state
(or Power-On state) is kept internally.
• An asterisk “*” character means you should consult a
footnote for this entry.
.
Table 6-1. Operational AT Commands
AT Command Brief Description
(reference page)
Value
Range
No Value
Definition
Power-
On/
Reset
Default
E Echo OFF|ON (p. 6-9) [0-1] 0 1
I Request Identification
Information (p. 6-9)
[0-2] 0 ^
Q Result Code Suppression
(p. 6-12)
[0-1] 0 0
V DCE Response Format
(p. 6-13)
[0-1] 0 1
X Result Code Selection
Command (p. 6-14)
[0-4] 0 4
Z Reset Default Configuration
(p. 6-15)
00^
&C DCE RLSD (DCD) Behavior
(p. 6-16)
[0-2] 0 1