Filter
Top Products
Integrator’s Reference Manual
5-14 80-99208-1 Rev. D
Nomenclature for Table 5-4
Table 5-4 defines the port(s) affected by AT commands that
may modify parameters other than those of the active AT
command port. The affected port(s) are listed for each of the
following three port configurations:
• Data port active only
• Control port active only
• Both Data and Control ports active
To define the affected port(s) for each AT command listed and
for each of the three port configurations, Table 5-4 uses the
following nomenclature:
• DATA — Applies to Data port
• CTL — Applies to Control port
• BOTH — Applies to both Data and Control ports
• NA — Not applicable to a port with this active port
configuration or not applicable to a port in general
Table 5-4. Port(s) Affected by AT Commands
Port Command Applies To:
AT Command AT Command
Description
Data Port
Active Only
Control Port
Active Only
Data & Control
Ports Both
Active
Z Reset to Default
Configuration
DATA BOTH BOTH
&C DCE RLSD (DCD)
Behavior
DATA DATA DATA
&D DTE DTR
Behavior
DATA DATA DATA
&F Set to Factory
Defined Default
Configuration
DATA BOTH BOTH
S777 Silent Retry
Timeout
DATA CTL CTL
+ICF Character
Framing Settings
DATA NA DATA