Filter
Top Products
AT Command Reference
80-99208-1 Rev. D 6-69
Set Mode ($QCMODE)
Syntax
$QCMODE[=<mode>|?|=?]
Description
This command sets the modem’s call mode. It does not affect
the Rm interface baud rate (set by the
+IPR command, as
described on page 6-38).
Note
When the modem is powered up, the modem call mode is set to 1
(auto-detect mode). However, when the modem is reset by the Z
command, the current call mode is left unchanged. Resetting with the
&F command does reset the call mode.
Values(s)
Note
Since the GSP-1620 modem is single-mode (Globalstar only),
“Auto-detect Mode” has the same effect as “Globalstar Only Mode.” The
GSP-1600 Tri-Mode Phone has two additional modes: digital cellular
and analog cellular.
Missing Parameter Default Value(s)
1
Power-On/Reset Default Value(s)
1
Results Returned
1 Auto-detect Mode
2 Globalstar Only Mode
Result Condition
OK <mode> is supported and Call
Mode is set.