Filter
Top Products
Integrator’s Reference Manual
6-30 80-99208-1 Rev. D
Valid Value(s)
Missing Parameter Default Value(s)
N/A
Power-On/Reset Default Value(s)
Results Returned
See Table 6-4 on page 6-24 for result code details.
Carrier Loss to Disconnect Timeout (S10)
Syntax
S10{=<value>|?}
Description
Specifies the amount of time, in 0.1 second increments, that
the DCE will remain connected before dropping DCD after
the signaling carrier is lost.
This parameter is valid only for asynchronous data services.
It is sent to the Gateway IWF modem if different from the
default value but is otherwise not used by the modem.
Valid Value(s)
Missing Parameter Default Value(s)
N/A
Power-On/Reset Default Value(s)
Results Returned
See Table 6-4 on page 6-24 for result code details.
0 Disabled
1-255 Number of tenths of a second delay
6 tenths of a second
1-254 Number of tenths of a second to wait
255 Disable timeout
14 tenths of a second