Filter
Top Products
Making Simple Data Calls
80-99208-1 Rev. D 4-5
Entering Online-Command Mode
While a packet data call is in progress on the Data port (the
modem is in Online mode), you can interrupt the data stream
so the modem will respond to AT commands. This puts the
modem into Online-Command mode.
1
2
3
Steps
TO ENTER ONLINE-COMMAND MODE
1. While the data call is in progress on the Data port, in
HyperTerminal, type this escape sequence: +++ .
HyperTerminal responds with
OK.
2. Type
AT$QCSTATUS <Enter>.
The modem responds with a status report. Notice that the
CALL TYPE field reads TIA_PPP, indicating that the data
call is still in progress
.
3. To terminate the call, type ATH <Enter>.
Tip
For more information about Online-Command mode, see Change from
Online to Online-Command Mode (+++) on page 6-40.