Filter
Top Products
AT Command Reference
80-99208-1 Rev. D 6-17
Valid Values
Power-On/Reset Default Value(s)
2
Results Returned
OK
or ERROR; see Table 6-3 on page 6-9 for details.
Set to Factory-Defined Configuration (&F)
Syntax
&F[<value>]
Description
Instructs the modem (DCE) to set all parameters to their
QUALCOMM-defined defaults. This command performs the
same operation independent of whether or not
<value> is
specified. QUALCOMM-defined defaults are the default
values for each AT command specified in this chapter.
This command sets the modem baud rate to its
power-on/reset default value (see Set Rm Interface Command
Baud Rate (+IPR) on page 6-38), but does not reset the
$QCMODE value to its power-on/reset value. (Compare the
behavior of the
Z command, Reset to Default Configuration (Z)
on page 6-15.)
If the modem is in Online-Command mode, the data call is
released and the modem returns to Command mode.
Valid Values
Power-On/Reset Default Value(s)
None.
0 DCE ignores DTR state.
1 DCE transitions to from Online to Online-Command
mode when DTR transitions from ON-to-OFF.
2 DCE closes connection (terminates call) when DTR
transitions from ON-to-OFF.
0 Resets modem parameters, except <call mode>
(set via $QCMODE), to their default values.