Filter
Top Products
AT Command Reference
80-99208-1 Rev. D 6-19
Results Returned
Repeat Last Command (A/)
Syntax
A/
Description
Although this is technically an AT command prefix and not
an AT command, it is listed in the command section for easy
reference.
This prefix repeats execution of the last command line
entered. If no command was entered previous to entering this
command, the previous command line is considered to be
empty and no action is taken.
Note
Previous command line execution begins immediately after / is
entered. It is not necessary to enter a termination character (carriage
return; see Command Line Termination Character (S3) on page 6-25 for
details) to begin execution of the previous command line body.
Result Code Description
OK Command is aborted either by reception of an
additional character from the DTE or by the
DTE turning off DTR (circuit 108) for &D1 and
&D2.
Also returned if there is no incoming call to
answer.
CONNECT Connection is successfully established (call is
active on traffic channel). This result code is
transmitted when the DCD (circuit 109) is
turned on.
NO CARRIER The connection could not be established; service
not activated, call cannot be completed, or
service unavailable.
ERROR Command was issued in Online-Command
mode.