Filter
Top Products
Integrator’s Reference Manual
6-14 80-99208-1 Rev. D
Values
Power-On/Reset Default Value(s)
1
Results Returned
OK
or ERROR; see Table 6-3 on page 6-9 for details.
Result Code Selection Command (X)
Syntax
X[<value>]
Description
Determines whether or not the DCE transmits particular
result codes to the DTE when connecting asynchronous data
services. This command is recognized but does nothing
locally. Normally it controls whether or not the DCE verifies
the presence of dial tone and/or busy signal on the line.
However, it is used only to allow a non-default value to be
sent to the Gateway IWF modem.
0 DCE transmits limited headers and trailers and
numeric result codes.
1 DCE transmits full headers and trailers and
alphabetic result codes.