Filter
Top Products
10 | CHAPTER 2 – BEFORE INSTALLING YOUR SMART BOARD 685ix
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
Environmental Requirements
Before installing your SMART Board 685ix interactive whiteboard system, review the
following environmental requirements.
SMART Board 685ix interactive whiteboard systems can operate in a temperature
range of:
• 41°F to 95°F (5°C to 35°C) from sea level to an altitude up to 6000' (0 m to
1829 m)
• 41°F to 86°F (5°C to 30°C) from 6000' to 9800' (1829 m to 2987 m).
The product can withstand storage temperatures from -4°F to 104°F (-20°C to 40°C).
CAUTIONS
• Never operate this unit immediately after moving it from a cold location to a
warm location. When the unit is exposed to such a change in temperature,
moisture can condense on the lens and crucial internal parts. Allow the
system to stabilize to room temperature before operation to prevent possible
damage to the unit.
• In a location at an altitude over 6000' (1829 m), the air is thin and cooling
efficiency is reduced, so use the projector with the fan mode set to High.
• Do not place in hot locations, such as near heating equipment. Doing so could
cause a malfunction and shorten the life of the projector.
Humidity
SMART Board 685ix interactive whiteboard systems can operate between 30% and
70% humidity, non-condensing. Humidity above 80% can cause slight wrinkling in the
sheet of the SMART Board 685ix series interactive whiteboard. The wrinkles
disappear once the humidity lowers.
Water and Fluid Resistance
SMART Board 685ix interactive whiteboard systems are for indoor use only and don’t
meet any salt-spray or water ingress requirements. Don’t pour or spray any liquids
directly onto the interactive whiteboard, the UX60 projector or any of its
sub-components. These liquids could get into areas where they could damage
sensitive electronic components. Refer to the chapter on maintenance (beginning on
page 49) for detailed instructions on cleaning your system’s components.