Filter
Top Products
76 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
Powerstate Response Field Description
Source Selection Controls
These commands switch input sources. The source type determines which
commands can be accepted.
Source Selection Command Description
Source Response Field Description
Field Description
powering The projector is turning on.
on The projector is on.
confirm off Confirm off describes command stage one of the two stage
off sequence. It isn’t a selectable powerstate.
cooling The projector is cooling.
idle The projector is off.
Command Response Field
Available When
Powered Off
get input input=[field] yes
set input [target] input=[field] no
Command Description
get input Returns the projector’s current input.
set input Sets the current input to one of the selectable fields.
Field Description
VGA1 Switches source to the VGA 1 input connector.
VGA2 Switches source to the VGA 2 input connector. If you
installed your interactive whiteboard system according to
the instructions, this is the wire management bundle input.
Composite Switches source to the Composite video connector. If you
installed your interactive whiteboard system according to
the instructions, this is the relay from the ECP.
S-Video Switches source to the S-Video input connector.
HDMI Switches source to the HDMI input port.
None None describes the “get input” command response while
the projector is turned off. It is not a selectable input.