Filter
Top Products
99-00984-20-B0
79 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
VGA Source Control Commands
These commands control the appearance of your VGA source. These settings are
unavailable when the projector is off, or when the VGA source is disconnected. See
page 74 for setting absolute and adjustment commands.
Additional Composite Video Source Controls
Your composite video source supports all the general source controls on page 77, as
well as the commands listed in this section. These settings are unavailable when the
projector is off, or when the composite video source is disconnected.
NOTE
Some of these commands are invalid with HDMI input and VGA video sources,
and will return the response “invalidcmd=[command]”.
Composite Video Source Information Commands
These commands inform you of the current composite video source settings. See
page 96 for descriptions of these commands.
Command Command Target Range Response
set frequency [value] Values between =-5 and =5 frequency=[value]
set tracking [value] Values between =0 and =31 tracking=[value]
set saturation [value] Values between =0 and =100 saturation=[value]
set tint [value] Values between =0 and =100 tint=[value]
set sharpness [value] Values between =0 and =31 sharpness=[value]
set hposition [value] Values between =0 and =100 hposition=[value]
set vposition [value] Values between =-5 and =5 vposition=[value]
Command Response
get saturation saturation=[current saturation setting]
get tint tint=[current tint setting]
get sharpness sharpness=[current sharpness setting]