Filter
Top Products
78 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
Additional VGA Source Controls
Your VGA source supports all the general source controls on page 77, as well as the
commands listed in this section. These settings are unavailable when the projector is
off, or when the VGA sources are disconnected.
NOTE
Some of these commands are invalid with HDMI input and composite video
sources, and will return the response “invalidcmd=[command]”.
VGA Source Information Commands
These commands inform you of the current VGA source settings. See page 94 for
descriptions of these commands.
set contrast [value] Values between =0 and =100 contrast=[value]
set whitepeaking [value] Values between =0 and =10 whitepeaking=[value]
set degamma [value] Values between =0 and =3 degamma=[value]
set red [value] Values between =0 and =100 red=[value]
set green [value] Values between =0 and =100 green=[value]
set blue [value] Values between =0 and =100 blue=[value]
set cyan [value] Values between =0 and =100 cyan=[value]
set magenta [value] Values between =0 and =100 magenta=[value]
set yellow [value] Values between =0 and =100 yellow=[value]
set videofreeze [target] =on
=off
videofreeze=[target]
set videomute [target] =on
=off
videomute=[target]
Command Response
get frequency frequency=[current frequency setting]
get tracking tracking=[current tracking setting]
get tint tint=[current tint setting]
get sharpness sharpness=[current sharpness setting]
get hposition hposition=[current horizontal position setting]
get vposition vposition=[current vertical position setting]
Command Command Target Range Response