Filter
Top Products
72 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
• All responses from the projector are terminated with a carriage return line
feed combination followed by a command prompt. Wait until you receive the
command prompt indicating the system is ready for another command before
proceeding.
• The room control feature of your projector is always on and active.
To configure
your computer’s
serial interface
1. Turn on your computer, and then start your serial communications program or
terminal emulation program.
2. Connect your computer to the serial connection cable you attached to the
projector in the procedure on page 28.
Depending on your terminal emulation program, a “List?” or “Prompt?” message
and a flashing command prompt cursor might appear. Do not enter projector
commands yet. Instead, configure your serial interface settings using the values in
the table on page 71.
3. Once you have configured your communications settings, press ENTER.
The “List?” or “Prompt?” message and a flashing command prompt cursor on the
following line appears.
NOTE
If no message or an error message appears, your serial interface
configuration isn’t correct. Repeat step 2.
4. Type commands to configure your settings.
NOTES
– To see a list of available commands, type ? and then press ENTER.
– When you’re using a terminal emulation program, turn on your program’s
local echo setting if you want to see characters as you type them.