Filter
Top Products
99-00984-20-B0
iii | INTRODUCTION – IMPORTANT INFORMATION
• If the lamp has shattered or burst:
– Call an authorized SMART reseller
for instructions. Do not attempt to
replace the lamp.
– Do not touch the glass fragments because they can cause injury.
– Leave and then ventilate the area where the lamp shattered or burst.
– Wash your hands thoroughly if you have come into contact with
lamp debris.
– Thoroughly clean the area around the projector, and discard any edible
items placed in that area because they could be contaminated.
• When returning the projector to the wall-mounting bracket, replace all of the
screws you removed when you removed the projector. Failure to do so can
result in the projector falling from the boom resulting in product damage and
personal injury.
CAUTIONS
• Avoid turning off the projector during the lamp ignition phase because this can
lead to premature lamp failure. Before turning off the projector, keep the lamp
on for a minimum of 15 minutes after turning it on to preserve the lamp life.
• When you switch the projector off, ensure that the cooling cycle is complete
before disconnecting the power. Allow 90 seconds for the projector to
complete the cooling cycle.
• Never operate this unit immediately after moving it from a cold location to a
warm location. When the unit is exposed to such a change in temperature,
moisture can condense on the lens and crucial internal parts. Allow the
system to reach room temperature before operation to prevent possible
damage to the unit.
• In a high altitude location where the altitude is over 6000' (1829 m), the air is
thinner and cooling efficiency is reduced, so use the projector with the fan
mode set to High.
• Do not block the projector’s ventilation slots and openings.
• Do not place in hot locations, such as near heating equipment. Doing so could
cause a malfunction and shorten the life of the projector.
• Do not set up or use the interactive whiteboard system in an area with
excessive levels of dust, dirt, humidity or smoke.
• Do not scrub the surface of the mirror with the supplied cleaning cloth. Use
the cloth with a light touch. Do not put cleaning solvents on the mirror or
cleaning cloth.