Filter
Top Products
99-00984-20-B0
53 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
Projector Ready Lights and Projector Status
The UX60 projector’s two indicator LED lights (Power and Diagnostic) are located on
the boom-mounted projector. Specific light sequences convey information about the
state of your projector, including warning messages and issues. The following table
describes projector warning messages and issues.
NOTE
Contact your authorized SMART reseller
if the Fan Failure Error or Color Wheel
Failure Error appears.
Solid red The projector is receiving power but isn’t communicating with a
computer. On the projector’s input/output panel, check the
ECP’s 7-pin mini-DIN connections at the projector. Confirm
that the projector input selection is set to the correct video
input source (VGA1 for primary computer, VGA2 for secondary
computer). Confirm that the USB connection from the
computer is connected to the appropriate computer connection
on the ECP or wire management bundle.
Solid green The interactive whiteboard is on and communicating with your
computer.
Flashing green The interactive whiteboard is on and communicating with your
computer, but it’s in Mouse mode. Confirm that SMART
software is installed on your computer.
Flashing amber The interactive whiteboard system is turning on, is in service
mode or it has detected a firmware error. On the projector’s
input/output panel, check the ECP’s 4-pin powered-mini-DIN
connection. If nothing changes after you check your
connectors, call your authorized SMART reseller
.
Interactive
Whiteboard
Ready Light
Status