Filter
Top Products
82 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
System Information Commands (Active)
These commands control the current system settings. These commands are
unavailable when the projector is off.
get fwvermpu fwvermpu=[current processor firmware version]
get fwverecp fwverecp=[current ECP firmware version]
Command
Command Target
Range
Response
set autosignal [target] =on
=off
autosignal=[current]
set lampreminder [target] =on
=off
lampreminder=[current]
set highbrightness [target] =on
=off
highbrightness=[current]
set autopoweroff [value] Values between =0
and =180
autopoweroff=[value]
set zoom [value] Values between =0
and =30
zoom=[value]
set projectorid [value] Values between =0
and =99
projectorid=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[current]
set projectionmode [target] =front
=ceiling
=rear
=rear ceiling
projectionmode=[current]
set startupscreen [target] =smart
=usercapture
=preview
startupscreen=[current]
set groupname [description] Enter a descriptor no
more than 12
characters long.
groupname=[description]
set projectorname [description] Enter a descriptor no
more than 12
characters long.
projectorname=[description]