Filter
Top Products
66 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
To access the service
menu’s password
1. Access the projector’s service menu by pressing the following buttons quickly on
the remote control: Down, Up, Up, Left and Up.
CAUTION
Do not adjust any settings in the service menu other than those listed in this
procedure. Changing other settings might damage or affect the operation of
your projector and will invalidate your warranty.
2. Scroll down to the Password Get field and press Enter on the remote control.
The password appears on-screen. Record the password.
3. Scroll down to the Exit field, and press Enter on the remote control to exit the
projector service menu.
Lamp Hour Counter Reset Instructions
When you replace the lamp, you need to access the projector service menu and reset
the lamp hour counter. To prevent accidental errors, only a system administrator
should perform this procedure. Change your lamp according to the instructions on
page 62.
To reset the projector’s
lamp hour counter
1. Access the projector’s service menu by pressing the following buttons quickly on
the remote control: Down, Up, Up, Left and Up.
CAUTION
Do not adjust any settings in the service menu other than those listed in this
procedure. Changing other settings might damage or affect the operation of
your projector and will invalidate your warranty.
2. Scroll down to the Lamp Hour Reset field and press Enter.
CAUTION
Do not use the Lamp Hour Reset feature unless you have just replaced the
lamp. Resetting the lamp hour counter on an old lamp might damage your
projector due to lamp failure.
3. Scroll down to the Exit field, and press Enter to exit the projector service menu.