Filter
Top Products
99-00984-20-B0
63 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
• When replacing the projector lamp:
– Turn the projector off and wait 30 minutes for the lamp to cool
completely (or before removing the projector from the wall-mounting
bracket, if necessary).
– Do not remove any screws other than those specified in the lamp
replacement instructions.
– Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
– Use only replacement lamps approved by SMART Technologies. Contact
your authorized SMART reseller
for replacement parts.
– Never replace the lamp assembly with a previously used lamp assembly.
– To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
– Recycle or dispose of the lamp as hazardous waste, in accordance with
local regulations.
You will require a Phillips screwdriver and a flat screwdriver.
To remove the old lamp 1. Turn off the power by pressing the power button twice on the remote control or
the ECP.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the wall outlet.
4. Pull the lamp cover forward
and remove it from the
projector. Put the lamp cover
in a safe place.
TIP
If the cover is difficult to
remove, insert a flat
screwdriver or small coin
into the slot on the bottom
of the lamp cover to gently
pry the cover open.