Filter
Top Products
84 | CHAPTER 6 – REMOTELY MANAGING YOUR SMART BOARD 685IX
INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
System Information Commands (Passive)
These commands control the current system settings. These commands are always
available, even when the projector is off.
NOTE
Sending the “restoredefaults” command reverses any menu changes you made to
the UX60 projector. This procedure is irreversible.
Network Commands
These commands control your UX60 projector’s network status and settings. These
settings are always available, even when the projector is off.
Network Information Commands
These commands inform you of the current network settings.
NOTE
The “get netstatus” information command displays the network interface’s current
connection status. The “disabled” response is returned unless the
“set vgaoutnetenable=on” command is sent first.
Command Command Target Range Response
set lamphrs [target] =0 lamphrs=0
set restoredefaults [none] restoredefaults=done
Command Response
get netstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
get vgaoutnetenable vgaoutnetenable=[current]
get dhcp dhcp=[current]
get ipaddr ipaddr=[current]
get subnetmask subnetmask=[current]
get gateway gateway=[current]
get primarydns primarydns=[current]
get macaddr macaddr=[MAC address]