Filter
Top Products
52 | CHAPTER 5 – MAINTAINING AND TROUBLESHOOTING YOUR SMART BOARD
685ix INTERACTIVE WHITEBOARD SYSTEM
99-00984-20-B0
ECP Ready Light and System Status
The ECP’s main power button also functions as a ready light.
Integrated Interactive Whiteboard Ready Light Status
Adding a UX60 projector and the ECP change the normal behavior of the ready light
on the serial controller in the interactive whiteboard. These status lights are different
from what you normally see on a SMART Board 685 interactive whiteboard, and are
only valid when the interactive whiteboard system is connected to a computer source.
These explanations only apply when a computer is connected to the VGA1 or VGA2
ports and the USB input and the input source is active.
Ready Light Status
Off The projector system isn’t receiving power. Confirm that the
projector is on, and that the power cable is connected. Confirm that
your power supply is on and active. At the projector, check your
power cord and the ECP’s 4 pin powered-mini-DIN connection. At
the ECP, check the DB25 connector. If nothing changes after you
check your connectors and power supply, call your authorized
SMART reseller.
Solid amber The projector is receiving power but is turned off.
Flashing green The projector is receiving power and is turning on.
Solid green The projector is on, the ECP is receiving power and is
communicating with the projector.
Flashing
amber
The interactive whiteboard system is about to turn off.
Interactive
Whiteboard
Ready Light
Status
Off The interactive whiteboard isn’t receiving power. Confirm that
the projector is on. Confirm that the interactive whiteboard’s
USB cable is connected to the ECP. On the projector’s input/
output panel, check the ECP’s 4-pin powered-mini-DIN
connection. If nothing changes after you check your
connectors, call your authorized SMART reseller
.