Filter
Top Products
Command Line Interface Reference 10-25
WS2000>admin(network.ap.default)> set
Description:
Sets the default Access Port parameters.
Syntax:
set beacon mode
<type>
enable/
disable
Sets the default for secure beacons of specified type <type> (one of
802.11a, 802.11b, or 802.11b/g) to enable or disable.
intvl
<type> <interval>
Sets the default beacon interval for specified radio type (one of 802.11a,
802.11b, or 802.11b/g) to <interval> in K-us (50–200).
ch-mode
<type>
fixed/
random
Sets the default channel mode for radios of <type> (one of 802.11a,
802.11b, or 802.11b/g) to fixed or random.
div
<type> <mode>
Sets the default antenna diversity for radios of <type> (one of 802.11a,
802.11b, or 802.11b/g) to <mode> (one of full, primary, or secondary).
dtim
<type> <period>
Sets the default DTIM period for radios of specified <type> (one of 802.11a,
802.11b, or 802.11b/g) to <period> number of beacons (1–50).
primary
<type> <wdix>
Sets the default primary WLAN <widx> (1 to 4) for 802.11a radios of
specified <type> (one of 802.11a, 802.11b, or 802.11b/g). The ESS ID
configured for this WLAN will be used in the 802.11a beacon as the primary
ESS.
Note: This parameter is used only for AP200 APs with 802.11a
radios.
rate
<type> <basic> <supported>
Sets the default basic and supported rates for radios of specified <type>
(one of 802.11a, 802.11b, or 802.11b/g). <basic> and <supported> must be
a comma separated list of rates, such as 6,9,11,15 with no spaces. Basic
rates are a subset of supported rates. The different types of radio support
the following rates.
A - 6|9|12|18|24|36|48|54
B - 1|2|5.5|11
G - 1|2|5.5|6|9|11|12|18|24|36|48|54
Note: For a G radio, basic rates must be a subset of B Rates in
order to associate legacy B stations.
reg
<type> <indoor> <ch> <pwr>
Sets the default regulatory parameters for radios of specified type (one of
802.11a, 802.11b, or 802.11b/g), where <indoor> is one of in or in/out;
<ch> is the channel to use, and <pwr> is the power (in dB from 4 to 20).
Select the value of <ch> from the appropriate list.
802.11b ch -- 1 to 14
802.11a ch -- 36,40,44,48,52,56,60,64,149,153,157,161
Note: Regulatory parameter values depend on the country of
operation and radio type. Refer to the documentation for specific
regulatory information.
rts
<type> <bytes>
Sets the default RTS threshold for radios of specified <type> (one of
802.11a, 802.11b, or 802.11b/g) to <bytes> (e.g., 2341).
short-pre
<type>
enable/
disable
By default, enables or disables the short preamble mode for radios of spec-
ified <type> (one of 802.11a, 802.11b, or 802.11b/g).