Filter
Top Products
Configuring a (Totally) Stub Area 107
Configuration Procedure Non-backbone area and backbone area configuration (area 1 is a
non-backbone area)
■ Configure Switch A.
# Create VLANs and configure IP addresses for the VLAN interfaces. The
configuration procedure is omitted.
# Configure OSPF for area 1.
<SwitchA> system-view
[SwitchA] ospf 1 router-id 1.1.1.1
[SwitchA-ospf-1] area 1
[SwitchA-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
# Configure OSPF for the backbone area.
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
■ Configure Switch B (refer to “Configure Switch A.” on page 107).
■ Configure Switch C.
# Create VLANs and configure IP addresses for the VLAN interfaces. The
configuration procedure is omitted.
# Configure OSPF for area 1.
<SwitchC> system-view
[SwitchC] ospf 1 router-id 3.3.3.3
[SwitchC-ospf-1] area 1
[SwitchC-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.1] network 10.4.1.0 0.0.0.255
■ Configure Switch D.
# Create VLANs and configure IP addresses for the VLAN interfaces. The
configuration procedure is omitted.
# Configure a static route of 1.0.0.0/8.
<SwitchD> system-view
[SwitchD] ip route-static 1.0.0.0 8 10.5.1.2
# Configure OSPF for area 2.
[SwitchD] ospf 1 router-id 4.4.4.4
[SwitchD-ospf-1] area 2
[SwitchD-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255
[SwitchD-ospf-1-area-0.0.0.2] network 10.5.1.0 0.0.0.255
[SwitchD-ospf-1-area-0.0.0.2] quit
Switch 5500G Release V03.02.04 All versions
Switch 4500 Release V03.03.00 All versions
Product series Software version Hardware version