Filter
Top Products
34
INFORMATION CENTER
CONFIGURATION GUIDE
Outputting Log
Information to a Unix
Log Host
Network Diagram Figure 105 Network diagram for outputting log information to a Unix log host
Networking and
Configuration
Requirements
Send log information with severity higher than informational to a Unix log host
with an IP address of 202.38.1.10. The information source modules are ARP and
IP.
Applicable Products
Configuration Procedure
■ Configuration on the switch.
# Enable the information center.
<3Com> system-view
[3Com] info-center enable
# By default, the system outputs information of all modules to the loghost
channel. To obtain the system information of the ARP and IP modules, you need to
disable the output of information of all modules to the log host.
[3Com] undo info-center source default channel loghost
# Set the host with an IP address of 202.38.1.10 to be the log host, set the
severity to informational, and the information source modules to ARP and IP.
[3Com] info-center loghost 202.38.1.10 facility local4
[3Com] info-center source arp channel loghost log level informationa
l debug state off trap state off
IP network
Switch
PC
Product series Software version Hardware version
Switch 5500 Release V03.02.04 All versions
Switch 5500G Release V03.02.04 All versions
Switch 4500 Release V03.03.00 All versions
Switch 4210 Release V03.01.00 All versions