Filter
Top Products
244 CHAPTER 26: XRN CONFIGURATION GUIDE
[3Com] sysname hello
The configurations and verification on Switch C are the same as those on a Switch
5500. Therefore they are omitted here.
Complete Configuration Complete configuration on the Switch 5500
n
To avoid repetition, only the complete configuration of Switch A is listed below.
■ Configuration on Switch A.
#
system-view
fabric-port GigabitEthernet 1/1/1 enable
fabric-port GigabitEthernet 1/1/2 enable
#
change unit-id 1 to 1
#
set unit 1 name Unit1
#
sysname hello
#
XRN-fabric authentication-mode simple welcome
Complete configuration on Switch 5500Gs switches
n
To avoid repetition, only the complete configuration of Switch A is listed below.
■ Configurations on Switch A.
#
system-view
fabric-port Cascade 1/2/1 enable
fabric-port Cascade 1/2/2 enable
#
change unit-id 1 to 1
#
set unit 1 name Unit1
#
sysname hello
#
n
The change unit-id and set unit name commands will not be saved in the
configuration file, that is, when you use the display current-configuration or
display saved-configuration command to view the content of the configuration
file, the two commands are not displayed.
Precautions
■ Before configuring an XRN fabric, make sure that the software versions of each
switch are the same.
■ Make sure that the switches in a fabric are correctly interconnected through
the fabric ports.
■ Establishing an XRN system requires a high consistency of the configuration of
each device. Hence, before you enable the fabric port, do not perform any
configuration for the port, and do not configure some functions that affect the
XRN (such as HWTACACS and VLAN-VPN) for other ports or globally.